E10

Issue

1. Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash.
2. Problem with not taking in water, not taken in enough water or problems with the drain
3. What does error code E10 mean in a washing machine?
4. Washing machine does not fill with water, error code E10 appears on display

Applies to

1. Washing machine
2. Top loader washing machine
3. Washer-dryer

Resolution

1. Low or no water supply
2. Blocked filters or hoses
3. Drainage problems
4. The machine is not filling with water
5. It is filling too slowly
6. There is a drainage issue
7. Make sure the water tap is fully open
8. Check that water pressure is adequate
9. Test by filling a bucket from the tap (you should fill ~10 litres in about a minute)
10. Turn off the water supply
11. Remove the inlet hose
12. Clean the small filter at the hose connection
13. Check the filter in the machine’s inlet valve
14. Reattach and ensure the hose is straight
15. Inspect both inlet and drain hoses behind the machine
16. Straighten any bends or twists
17. Replace damaged hoses if necessary
18. Make sure the drain hose is not inserted too far into the drain
19. Check that it extends no more than 10 cm into the pipe
20. Verify the drain height is between 60 cm and 100 cm
21. Open the pump filter access panel
22. Remove debris, lint, and foreign objects
23. Check that the pump impeller rotates freely
24. Run a hot wash without detergent to flush the system
25. Test draining into a sink or bucket
26. Ensure household drains are not clogged
27. Check wastewater flow
28. Avoid overdosing detergent
29. Run an empty cycle to remove excess foam
30. Unplug the appliance
31. Wait at least 30 seconds
32. Plug it back in and restart the cycle
33. The error persists after completing all checks
34. Water is not entering the machine at all
35. You suspect a faulty inlet valve, pump, or sensor
36. Water supply problems
37. Blocked hoses or filters
38. Drainage issues
39. Incorrect detergent use