What AEG recommends
Issue
- The washing machine displays error messages E30, C3 or emits 3 beeps/3 flashes
- Washing machine is leaking
Applies to
- washing machine
- washer dryer
Resolution
- Disconnect the appliance from the water and power supplies and then place a towel behind the washing machine on the floor.
- Tilt the appliance backwards a little, so that there is around 10–15 cm between the floor and the kickboard on the front.
- Hold the appliance in position for about 30–40 seconds to allow the water in the bottom tray to flow out onto the towel.
- Lower the appliance to the floor and reconnect it.
- Check the water supply and drainage.
- Check if the filters in the inlet hose and water valve are clean (where the inlet hose is screwed onto the appliance and at the water tap).
- Start a wash cycle and see whether the problem has been resolved.
AEG shows how
1:06
Play on YouTube:
1:09
Play on YouTube:
Videos are the manufacturer's own, embedded on its pages; they play from YouTube when you press play.
Which appliances this applies to
Documented by AEG for its washing machines generally, not for a specific model.
Frequently asked questions
How do I fix AEG E30?
Issue: 1. The washing machine displays error messages E30, C3 or emits 3 beeps/3 flashes 2.
Where these facts come from
- AEG error code page retrieved 3 November 2026
Every fact on this page was read from the manufacturer's own product page or document at the address shown, and is labelled with how far it has been checked. Last updated 3 November 2026. Read how we source data, or report an error.